Sony VPL-FHZ101, Operating Instructions Manual

Page: 13 / 64

13
Attaching the Projection Lens
 Avoid removing/attaching the lens with the projector
installed suspended from a ceiling.
 For usable projection lenses, see “Optional accessories”
(page 54).
 Do not attach any lens other than the specified accessory
lens sold separately.
 Be careful not to drop the projection lens.
 Avoid touching the lens surface.
1
Turn off the projector, then unplug the AC
power cord from the wall outlet.
When replacing the lens, your eyes may be
damaged if a strong light accidentally gets into
your eyes. Before replacing the lens, turn off the
projector and then unplug the AC power cord.
2
Remove the lens cover.
While sliding the LENS COVER RELEASE
buttons inward, pull out the lens cover until it
clicks into place.
3
Turn the contact substrate to the left facing
the front of the lens and insert the lens to the
end.
4
While pressing the slide switch, lower the
lever until it clicks into place.
5
Attach the lens cover.
Hang the upper side of the lens cover on the
top cover of the projector and press it until it
clicks into place. Then, while sliding the LENS
COVER RELEASE buttons inward, insert the
lens cover.
Even when the lens is attached, you can attach/
remove the lens cover in the same way.
1
Return the projection lens to the center
position.
While the projector is turned on, press the
LENS SHIFT key on the Remote Commander,
then press the RESET key on it. The projection
lens returns to the center position.
2
Turn off the projector, then unplug the AC
power cord from the wall outlet.
When replacing the lens, your eyes may be
damaged if a strong light accidentally gets into
your eyes. Before replacing the lens, turn off the
projector and then unplug the AC power cord.
3
Remove the lens cover.
4
While pressing the slide switch, move the
lever up to the limit, and pull the lens straight
out.
5
Attach the lens cover.
Notes
Caution
LENS COVER RELEASE
buttons
Removing the Projection Lens
Caution
Lever
Lever
Slide switch