Your new hard disk drive is supplied with the necessary screws. Do not overtighten these screws when securing
the drive to the drive holder.
9.
Align the drive holder with the tracks on the inside of the chassis. Slide the drive holder in completely.
10.
Push the drive holder handle down to lock the drive into position.
11.
Connect the second drive connector to the new drive. Orient the connector to align pin 1 on the red side of the
ribbon cable with pin 1 on the new drive.
12.
Connect the second power connector to the new drive following the instructions supplied with the drive.
Replacing the driv e holder
13.
Replace the side panel. See
About Closing the Computer
.
14.
Reconnect the power cord to your computer.
Page 200
Summary of Contents for VAIO VGC-RA910G Series
Page 11: ...Page 11 ...
Page 31: ...Page 31 ...
Page 65: ...Logs off from this computer or enables you to switch users Page 65 ...
Page 161: ...Page 161 ...