Get
ting St
ar
te
d
Loading Paper in the Unit
11
2
Press the OPEN button to open the paper door.
3
Remove the label from the leading edge of the
paper, pull out about 15~20 cm (about 6~8 in.) of
the paper, and then set the paper roll in the paper
tray.
Note
To avoid exposing the paper to dust, dirt, etc.
always handle it carefully when removing from its
package and loading it in the unit. Paper exposed to
dirt or dust cannot be used for printing.
4
Close the paper door and press on it to shut it.
Notes
• Make sure that the paper is loaded straight. If it is
skewed, this could cause the paper to jam.
• If you did not pull out enough paper in step 3, press the
FEED button on the operation panel to feed some
more paper out of the unit without pulling out the
paper.
Remove label and pull
out 15 to 20 cm (about 6
to 8 inches).
Load the paper with the printing side (heat
sensitive side) up. Printing is not possible if the
paper is reversed.
Make sure that the paper is set
straight.