11
Preparation
Note
If the printer is connected at the physical end of the SCSI bus, set the built-in
terminator to ON. (See page 12.)
Installing the Printer Driver Program
The printer driver program should be installed before starting operation.
The instruction manual for the printer driver is stored on the supplied CD-ROM.
For details, read the ReadMe file on the CD-ROM.
Setting the DIP Switch
The DIP switches on the rear panel determine the on/off state of the internal SCSI
bus terminator and the SCSI device ID number.
As shipped from the factory, the DIP switches are set up as follows:
Terminator ON/OFF setting
If printer is located at the physical end of the SCSI bus, this switch should be set to
ON. Otherwise, if another device is at the end of the bus, this switch should be
OFF.
When connecting a printer via the SCSI interface
Switch
TERMINATOR
ON
The internal terminator is ON.
a)
OFF
The internal terminator is OFF.
ON 4 2 1
OFF 0 0 0
TERMINATOR
SCSI ID
(Factory setting)
a) Factory setting
SCSI cable (shielded type)
(50 pin full/50 pin half pitch -
50 pin half pitch)
