–
8
–
KV
-XA29M60/XA29M84
RM-954 RM-953
4
Using Your New TV
1
2
3
R
L
Y
C
B
C
R
VIDEO
VIDEO IN
VIDEO OUT
AUDIO
R L
Getting Started
CAUTION
• Do not connect the power cord until you have completed making all other
connections; otherwise a minimum leakage current might flow through
the antenna and other terminals to ground.
• To avoid battery leakage and damage to the remote, remove the batteries
from the remote if you are not going to use it for several days. If any
liquid that leaks from the batteries touches you, immediately wash it
away with water.
Step 1
Connect the antenna
If you wish to connect a VCR, see the
Connecting a VCR
diagram below.
Connecting a VCR
To watch the video input, press
t
(see page 11).
IEC connector
(not supplied)
To video and
audio outputs
VCR
(yellow)
-L (MONO) (white)
-R (red)
To S video
output
Antenna cable (not supplied)
To
t
1, 2 or 3
(video input)
Audio/Video cable
(not supplied)
S video cable
(not supplied)
: Signal flow
To
(S video input)
To antenna
output
To
8
(antenna)
or
: Signal flow
Antenna cable (not supplied)
Antenna cable (not supplied)
Rear of TV
Rear of TV
Using Your New TV
5
Using Your New TV
Using Y
our New TV
PROGR
MENU
AUTO
PROGR
ENTER
SELECT
L(MONO)
3
1
2
AUTO PROGRAM
PR : 01
TV SYS : B/G
VHF LOW
Notes
• If you connect a monaural VCR, connect the yellow plug to
(the
yellow jack) and the black plug to -L (MONO) (the white jack).
• If you connect a VCR to the
8
(antenna) terminal, preset the signal
output from the VCR to the program number 0 on the TV.
• If both
(S video input) and
t
1 (video input) at the rear of your TV
are input at the same time, the
(S video input) is automatically
selected. To view the video input to
t
1 (video input), disconnect the
S video cable.
• Do not connect video equipment to
t
3 (video input) at the front and
the rear of your TV at the same time; otherwise the picture will not be
displayed properly on the screen.
• When no signal is input from the connected video equipment, the TV
screen becomes blue.
Step 2
Insert the batteries
into the remote
Note
• Do not use old batteries nor use different types of batteries together.
Step 3
Preset the channels automatically
Tips
• If you want to stop the automatic channel presetting, press MENU.
• If your TV has preset an unwanted channel or cannot preset a particular
channel, then preset your TV manually (see page 31).
Note
• During automatic channel presetting, your TV screen will indicate “B/G”,
“I”, “D/K” or “M” for the TV system (“TV SYS”).
Front of TV
