–
21
–
KV
-XA29M60/XA29M84
RM-954 RM-953
33
Additional Information
Additional Information
Self-diagnosis function
Your TV is equipped with a self-diagnosis function. If there is a
problem with your TV, the
1
indicator flashes red. The number of
times the
1
indicator flashes indicates the possible causes.
1
Check that the
1
indicator flashes red a number of times between 3-second
intervals.
2
Count the number of times the
1
indicator flashes.
3
Press
!
(main power) to turn off your TV.
4
Inform your nearest Sony service center about the number of times the
1
indicator flashes.
Be sure to note the model name and serial number located on the rear of
your TV.
Front of TV
1
indicator
PROGR
MENU
AUTO
PROGR
ENTER
SELECT
L(MONO)
3
Additional Information
34
Additional Information
Troubleshooting
If you find any problem while viewing your TV, please check the following guide. If
any problem persists, contact your Sony dealer.
Possible cause
Symptom
Solutions
• Connection is loose or
the cable is damaged.
• Channel presetting is
inappropriate or
incomplete.
• The antenna type is
inappropriate.
• The antenna direction
is inappropriate.
• Signal transmission is
low.
• Broadcast signals are
too strong.
• The TV system setting
or channel presetting
is inappropriate or
incomplete.
• The power cord,
antenna or VCR is not
connected.
• The TV is not turned
on.
• Check the antenna cable and connection
on the TV, VCR and on the wall.
• Display the “CH PRESET” menu and
select “MANUAL PROGRAM” to preset
the channel again.
• Check the antenna type (VHF/UHF).
Contact a Sony dealer for advice.
• Adjust the antenna direction. Contact a
Sony dealer for advice.
• Try using a booster.
• Display the “CH PRESET” menu and
select “MANUAL PROGRAM”. Then,
select “
SENS: LOW”.
• Turn off or disconnect the booster if it is
in use.
• If the sound of all the channels are noisy,
display the “CH PRESET” menu and
check the TV system (“TV SYS”) setting,
then select “AUTO PROGRAM” to preset
the channels again.
• If the sound of some channels are noisy,
select the channel, then display the “CH
PRESET” menu and select the appropriate
TV system (“TV SYS”).
• Check the power cord, antenna and the
VCR connections.
• Press
?/1
(power).
• Press
!
(main power) on the TV to turn
off the TV for about five seconds, then
turn it on again.
Snowy picture
Noisy sound
Distorted picture
Noisy sound
Good picture
Noisy sound
No picture
No sound
Page
4
30
–
–
–
30
–
30
30
4
10
10
