Sony SU-PW2, Instructions Manual

Page: 14 / 84

SU-PW2 4-099-792-42(1)
14
(GB)
Connect the mains lead and the connecting
cable(s) supplied with the Display Unit to the
Display Unit.
Connect the mains lead and the connecting cable(s) to
the connectors on the rear side of the Display Unit. For
details on connecting the mains lead and the connecting
cable(s), refer to the instruction manual of the Display
Unit.
When you route the cable and the lead in the wall, feed
them through the hole you bored (page 10).
The position of the hole that should be bored varies
depending on the model of the Display Unit.
Notes
• Once you install the Display Unit to the Plate Unit, you cannot
connect the lead and the cables.
• Be sure to subcontract the routing of the cable in the wall and
electrical work to qualified contractors.
Step 4: Install the Display Unit
WARNING
Be sure to complete the installation before connecting the mains lead to the wall socket. If you allow the mains
lead to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock.
Be careful not to stumble over the mains lead or the Display Unit, as you may hurt yourself.
Hitch the Mounting Hook Unit on the hooks on
the rear side of the Display Unit. Then slide the
Mounting Hook Unit and fix it using the
supplied screws (+PSW5
×
L16).
1
Rear side of the Display Unit
(The model of the Display Unit in the illustration is PDM-4200.)
Soft rag
2
PDM-4200
PDM-5000
PDM-6100
KE-MX37A1
KE-MX37S1
KE-MX37N1
KE-MX37K1
KE-MX42A1
KE-MX42S1
KE-MX42N1
KE-MX42K1
KE-MX42M1