Sony SU-PW2, Instructions Manual

Page: 11 / 84

SU-PW2 4-099-792-42(1)
GB
11
(GB)
Adjust the angle of the arms.
When installing the Display Unit perpendicularly (0
degrees), adjustment of the arms angle (Procedure
1
and
2
below) is not necessary. Make sure that each arm
base is screwed in securely.
1
Remove the screws that are at the top and bottom
centre of the both arm bases. Then choose the notch
corresponding to the desired angle (5, 10, 15 or 20
degrees) and fit the arm base to it.
2
Firmly secure each arm base using the screws
removed in Procedure
1
.
Notes
• Be sure to adjust the angles of the right and left arms to the same
angle.
• Be careful not to pinch your fingers when adjusting the angle of
arms.
• When using an electric screwdriver, set the torque setting to
approximately 2 N·m.
• Make sure that two Mounting Hook Unit support shaft on the lower
part of the Plate Unit are screwed in securely.
2
2
1
• 0 degrees: Leave the white screws tightened as
they are.
• Other than 0 degrees: Remove the white screws.
Arm Base
Step 3: Install the Plate Unit on the wall
1
Fix the Plate Unit to the wall using four or more
M8 (or equivalent) screws (not supplied).
Select at least four screw holes with the same mark
shown in the diagram on the right, and tighten the
screws securely so that they will not come loose.
WARNING
• The screws securing the Wall-Mount Bracket to the wall are not
supplied.
• Be sure to use the appropriate screws, depending on the material and
structure of the wall.
• If the Plate Unit cannot be attached securely enough, use additional
screws.
• Be sure to confirm that the Plate Unit is securely fixed to the wall.
Align the unit so that it is exactly level.
Plate Unit