Sony SRX-R320, Installation Manual

Page: 99 / 126

3-5
SRX-R320
Message No. Error message Trouble Remedy
FAIL_19 LENS ERROR Focus operation is failed. Check the lens and lens cable. Check the
SY board. Replace the SY board if it is
damaged.
FAIL_21 ADJUSTMENT ERROR The Z-axis operation is failed. Check the lamp house-supplied motor and
harness. Replace the motor if it is dam-
aged. Check the SY board. Replace the
SY board if it is damaged.
FAIL_24 ADJUSTMENT ERROR Calibration is failed. Perform recalibration, check the lamp
(luminance deterioration). Replace the
lamp bulb if it is deteriorated.
FAIL_25 DEVICE ERROR FPGA con fi guration fails. Turn off the power once, then turn on it
again.
FAIL_26 DEVICE ERROR I
2
C communication error. Turn off the power once, then turn on it
again.
FAIL_27 DEVICE ERROR LVDS error Turn off the power once, then turn on it
again.
FAIL_28 DEVICE ERROR PLL error Turn off the power once, then turn on it
again.
FAIL_29 DEVICE ERROR Parity error Turn off the power once, then turn on it
again.
FAIL_30 BALLAST ERROR The power unit for lamp is interlocked. Turn off the power once, then turn on it
again.
FAIL_34 ADJUSTMENT ERROR The Z-axis is gotten out of range in the
+
direction.
Readjust the Z-axis and save it. Return
the Z-axis in the
_
direction.
(Refer to Section 2-2.)
FAIL_35 ADJUSTMENT ERROR The Z-axis is gotten out of range in the
_
direction.
Readjust the Z-axis and save it. Return
the Z-axis in the
+
direction.
(Refer to Section 2-2.)
FAIL_36 DEVICE ERROR Setting error of DVI. Check the setting and set the operation
again.