Sony SRX-R320, Installation Manual

Page: 89 / 126

2-43
SRX-R320
1314 pixel 1714 pixel 2160 pixel
4096 pixel
3696 pixel
1760 pixel 2160 pixel
4096 pixel
3996 pixel
3596 pixel
Fig. 2-8-3e
 ANAMORPHIC MODE
Sets the mode when the anamorphic lens is attached. And sets the squeeze ON/OFF when the standard
lens is installed.
n
When Scope or Flat is set, a signal convert to the anamorphic lens size data (1280
x
720 or 1920
x
1080),
even if the signal input from INPUT A / B is not DCP.
.
Off: Normal image size
.
Scope: When the anamorphic lens is attached, this is selected in the case of the DCP for Scope size.
.
Flat: When the anamorphic lens is attached, this is selected in the case of the DCP for Flat size.
.
Squeeze: When the normal lens is attached, this is selected when you want to set Squeeze for aspect.
 LENS CONTROL
Adjusts the image projected on the screen.
.
ZOOM: Adjusts the size of an image. An image is expanded when you click the
[+]
button. It is
reduced when you click the
[_]
button.
.
FOCUS: Adjusts a focus. A focus is adjusted to the distance place when you click the
[+]
button. It is
adjusted to the nearby place when you click the
[_]
button.
 ELECTRIC V SHIFT FUNCTION
Adjusts the vertical position of the projection screen electrically. The screen moves upwards when a
setting value increases. It moves downwards when a setting value decreases. The setting value is re-
turned to the factory setting when you click the
[RESET]
button.
 TEST PATTERN
An image can be adjusted by projecting the test pattern, built in this unit, on the screen without inputting
the signal from other equipment.
Each test pattern is as follows:
.
Cross Hatch (Invert)
.
Checker Flag
.
Scope
.
Flat
Select Off when not projecting a test pattern on the screen.
n
The test patterns Scope and Flat are as shown in the fi gure below.
When installing, those patterns are used in fi tting the image size or masking the projection data.
Scope Flat