Sony SRW-9000, Operation Manual

Page: 186 / 207

Warning/Error Messages 186
App
end
ix
e
s
When the unit stops operating correctly because
of an internal error, a warning tone sounds and a
popup window appears on the display of the
control panel with an error message.
Only one message is displayed at one time, even
if multiple errors occur. But the number of current
errors appears at the bottom of the popup
window.
At the same time, a VTR module error message
appears in the viewfinder and in the message
display section of the monitor screen.
When an error message appears
Check the message and eliminate the cause of the
error.
If the error involved the tape transport
mechanisms (SLACK-35, etc.), contact a Sony
service representative.
For other errors, power the unit off and on again.
If the same error message appears again when the
unit is powered on, contact a Sony service
representative.
To close the error message popup window
Press the menu selection button “HOME” or
“BACK” on the control panel.
If you press the HOME button, an error code
appears in the operation status and warnings
section of the control panel display
(see page 25) .
If you press the BACK button, the same error
code appears in the operation status and warnings
section of the display when you move back as far
as the HOME screen.
The error code remains visible until the cause of
the error is eliminated.
Tape protection mode
To protect the tape and the mechanical parts of
the unit, the servo control system automatically
stops tape transport and the drum motor and
enters tape protection mode when an error occurs.
Cassettes may not be inserted or ejected while the
unit is in tape protection mode.
Error messages
Refer to the Maintenance Manual for more detailed
information about the content of error messages, and
about errors not listed here.
VDA ROM
MISMATCH A wrong VDA_PLD version has
written.
ANOTHER TYPE
OHB Software (ROM data) for the
camera module does not match to
the CCD unit.
Viewfinder screen
Basic status
display
(see
page 60)
Message Subdisplay RUN indicator Meaning
Error Messages Related to the
VTR Module
Example:
Popup window displaying error
message “007F HUMID ERROR”
(condensation detected)
There is one current error.
There are two current warnings (see page 187) .
To view the other messages, turn the SELECT/
ENTER dial on the control panel.
Code Message Description
0010 FAN STOP A cooling fan stopped.
0011
0012 ACC POWER
NG Error was detected in
current flow monitoring
circuits. Check the
connected accessories.