9
Getting Started
Getting Started
A/V hookup:
VCR setup
After you’ve connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Caution
Connections between the VCR’s VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure to
do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer’s attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
continued
Press MENU and select
ADVANCED OPTIONS.
Set AUTO ANT SELECT
to OFF and press OK.
For details, see page 54.
SELECT
SET
QUIT
:
:
:
TIMER SET/CHECK
SETTINGS
ADVANCED OPTIONS
O K
MENU
t
t
,
SELECT
SET
QUIT
:
:
:
ADVANCED OPTIONS
O K
MENU
t
t
3
RETURN
AUTO ANT SELECT
AUTO STEREO
TUNER AUDIO
TAPE SELECT
AUTO TAPE SPEED
SHARPNESS
APC
ON
OFF
ON
AUTO
ON
L H
