3
3
SA-WM20
SECTION 1
GENERAL
• Location of controls
– Front view (a part) –
SECTION 2
DIAGRAMS
1
2
3
4
5
1
POWER (
@/1
) button
2
POWER indicator
3
PHASE (
4
NORMAL/
$
REVERSE) button
4
CUT OFF FREQ dial
5
LEVEL dial
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
C
: panel designation.
For printed wiring boards.
Note:
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
b
: Pattern from the side which enables seeing.
•
: B+ Line.
•
: B– Line.
• Voltages are dc with respect to ground under no-signal con-
ditions.
no mark : Power on
∗
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10M
Ω
).
Voltage variations may be noted due to normal preduction
tolerances.
• Signal path.
K
: AUDIO
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND
SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
2-1. Circuit Boards Location
MAIN board
POWER IC board
LED board
SWITCH board
CONTROL board
Note:
The components identi-
fied by mark
0
or dotted
line with mark
0
are criti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque
0
sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce por tant le numéro
spécifié.
• Abbreviation
CND : Canadian model
SP
: Singapore model
MX
: Mexican model
MY
: Malaysia model
