Sony RM-1000BP, Operating Instructions Manual

Page: 27 / 96

-GB
Preparation before Use
Connecting this unit to the video camera
1 Place this unit at a stable place. Check that the power of the video
camera is set to “OFF.”
Turn downward the lever portion of the accessory cable jack side.
Insert it straight into the terminal on the back side of this unit and
rotate the accessory cable jack 90 degrees in a clockwise direction to
lock it.
Connect the plug side of the accessory cable to the video camera.
If this unit is separated from the video camera, use the accessory cable (10 m).
Do not connect any cable to this unit other than the accessory cable. Do not connect the
accessory cable 1 m and 10 m.
Plug side
Jack side
Setting the video camera to recording status
For details, refer to the operating instructions provided with your video camera.
Set the power of the video camera to “ON” and cancel the auto-adjust
recording status*.
The POWER LED and REC LED of this unit light in red and then change to green. Then
POWER LED lights in green.
* The operating switch that sets and cancels the auto-adjust recording status of the video
camera varies depending on the video camera. (AUTO LOCK switch, AUTO/MANUAL
switch etc.)
Cancel the auto-adjust recording status of the video camera. Check that each function can
be adjusted manually. When the video camera is in the auto-adjust recording status, the
POWER LED blinks slowly in green.
When the remaining tape or battery power is low, the REC LED will blink in red.



