6
US
Do not step on the stand.
If you do so, you may fall from
the stand resulting in injury.
This stand is only for the specified TV.
• Do not place unspecified objects, such as a flower vase or pottery on
the stand.
• Do not make alterations to the stand.
Secure the TV to the stand.
If you fail to do so, the TV may fall or the stand may topple
over. This may cause injury. Following the instructions in this
manual, place the TV legs into the stopper and use the support
belt to prevent the TV from toppling over.
Note on load capacity
Do not place any equipment exceeding the specified
maximum weight on the stand, as indicated in the illustration
below. Otherwise, it may fall or break.
Notes on installation
• Be careful not to pinch your hand or fingers between the TV and the
stand.
• To prevent the stand from distorting, observe the following:
– Install the stand on a solid and flat surface.
– If you install the stand on a soft surface such as a mat, first lay a
board under the stand.
– Do not install the stand in a place subject to direct sunlight or near
a heater.
– Do not install the stand in a hot or humid place, or outdoors.
• Moving the stand requires four people or more. Move the stand only
after removing the TV. If you fail to do so, the TV may fall from the
stand resulting in serious injury. Do not hold the grille as it may
detach from the stand resulting in serious injury. Be careful not to
pinch your fingers when moving the stand.
Notes on use
• Do not place any hot objects on the stand. If you do so, the stand may
discolor or distort.
• To keep the stand clean, occasionally wipe the stand gently with a
dry, soft cloth. Stubborn stains may be removed with a cloth slightly
dampened with diluted detergent, followed by a soft dry cloth. Do
not use any type of chemicals, such as thinner or benzine, as they
may damage the finish of the stand.
• When placing the top front cover on the floor after removing it from
the stand, cover the floor with a cloth, etc., beforehand to protect the
floor from damage.
Inserting batteries into the remote
You can control the system using the supplied remote. Insert
two size AA (R6) batteries by matching the + and
−
ends on
the batteries to the markings inside the compartment.
• Do not leave the remote in an extremely hot or humid place.
• Do not use a new battery with an old one.
• Do not drop any foreign object into the remote casing, particularly
when replacing the batteries.
• Do not expose the remote sensor to direct light from the sun or
lighting apparatus. Doing so may cause a malfunction.
• If you do not intend to use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery leakage
and corrosion.
CAUTION
65 kg (143 lb 5 oz)
16 kg (35 lb 5 oz)
25 kg (55 lb 2 oz)
Note
