192
Condensation
If the unit is suddenly taken from a cold to a warm
location, or if ambient temperature suddenly
rises, moisture may form on the outer surface of
the unit and/or inside of the unit. This is known as
condensation. If condensation occurs, turn off the
unit and wait until the condensation clears before
operating the unit. Operating the unit while
condensation is present may damage the unit.
Fitting the zoom lens
It is important to fit the lens correctly, as
otherwise damage may result. Be sure to refer to
the section
“Mounting and Adjusting the Lens”
Viewfinder
Do not leave the camcorder with the eyepiece lens
pointing directly at the sun.
The eyepiece lens can concentrate the sun’s rays
and melt the interior of the viewfinder.
About the LCD panels
The LCD panel fitted to this unit is manufactured
with high precision technology, giving a
functioning pixel ratio of at least 99.99%. Thus a
very small proportion of pixels may be “stuck”,
either always off (black), always on (red, green,
or blue), or flashing. In addition, over a long
period of use, because of the physical
characteristics of the liquid crystal display, such
“stuck” pixels may appear spontaneously. These
problems are not a malfunction. Note that any
such problems have no effect on recorded data.
Phenomena specific to image sensors
Note
The following phenomena that may occur in images are
specific to image sensors. They do not indicate a
malfunction.
White flecks
Although the image sensors are produced with
high-precision technologies, fine white flecks
may be generated on the screen in rare cases,
caused by cosmic rays, etc.
This is related to the principle of image sensors
and is not a malfunction.
The white flecks especially tend to be seen in the
following cases:
• when operating at a high environmental
temperatures
• when you have raised the gain (sensitivity)
• when using the slow shutter
Vertical smear
When an extremely bright object, such as a strong
spotlight or flashlight, is being shot, vertical tails
may be produced on the screen, or the image may
be distorted.
Aliasing
When fine patterns, stripes, or lines are shot, they
may appear jagged or flicker.
Fragmentation
If pictures cannot be recorded/reproduced
properly, try formatting the recording medium.
While repeating picture recording/playback with
a certain recording medium for an extended
period, files in the medium may be fragmented,
disabling proper recording/storage. In such a
case, make a backup of clips in the medium then
perform formatting of the medium using
Operation >Format Media
in the
setup menu.
Notes on security
• SONY WILL NOT BE LIABLE FOR
DAMAGES OF ANY KIND RESULTING
FROM A FAILURE TO IMPLEMENT
PROPER SECURITY MEASURES ON
TRANSMISSION DEVICES,
UNAVOIDABLE DATA LEAKS
RESULTING FROM TRANSMISSION
SPECIFICATIONS, OR SECURITY
PROBLEMS OF ANY KIND.
• Depending on the operating environment,
unauthorized third parties on the network may
be able to access the unit. When connecting the
unit to the network, be sure to confirm that the
network is protected securely.
• Communication content may be unknowingly
intercepted by unauthorized third parties in the
Monitor screen
Vertical tails shown on the
image
Bright object (e.g., strong
spotlight, strong reflected
light, flashlight, the sun)
