Sony PWS-110RX1, Installation Manual

Page: 15 / 22

1-9 (E)
PWS-110RX1
3. Loosen the screws at the rear of the each adaptor, and
then adjust each adaptor length to the rack depth.
(The illustration below shows the left adaptor.)
Adaptor
Portion of
the rail
B4
)
6
(Length adjustment
screws)
t
Maximum depth of adaptor: 750 mm
Minimum depth of adaptor: 600 mm
4. Mount four positioning plates and the right and left
adaptors with the specified six screws (B4
x
10).
(The following figure shows the left adaptor.)
n
Insert the four bosses on each positioning plate into the
square holes of the rack.
31.75
1U
31.75
Unit: mm
Positioning plate
Front
Positioning plate
Bosses
Bosses
Square
Holes
B4
)
10
B4
)
10
Positioning plate
Viewed from inside
the rack angle
Rear
5. Tighten the length adjustment screws (B4
x
6, two
screws for each bracket) which are loosened in step 3.
6. Align the bent section of the each rack bracket on the
side panels of the unit to the rail, and then slide the unit
backward.
t
Each rack bracket covers the rails as shown in the
figure below.
Rack bracket
Rail
Rack bracket
Rail
n
When the unit is pulled out about 270 mm, the rack brack-
ets are disengaged from the rails.
When you pull out the unit, support the bottom of the unit
firmly so that you do not drop it.
7. Secure the rack angles to the rack with the specified
four screws (B5
x
12).
n
Use the screws (B5
x
12) supplied with the unit.
B5
)
12
B5
)
12