PS-HX500
13
2-9. MOTOR ASSY (M1)
front side
bottom side
2
three screws
(STEP
M2.5
u
1.5)
3
motor assy
(M1)
1
Remove the
four
solders.
:LUHVHWWLQJ
SW board
motor assy (M1)
[yellow: 5 pin]
6 pin
[yellow: 6 pin]
[red]
[black]
5 pin
front side
top side
Note 3:
Removing the two screws
is not necessary.
Note 3:
Removing the screw
is not necessary.
Note 4:
If you remove the three screws (step 2), the motor assy
will fall. When removing the screws, make sure that
you hold the motor assy.
Note 1:
When turning the main unit over, refer to “NOTE IN THE
CASE OF THE REVERSING THE MAIN UNIT” on page 3.
Note 2:
When replacing the motor assy, refer to “DC MOTOR SPEED
ADJUSTMENT” on page 15.