1-1 (E)
PFV-L02
Section 1
Installation
1-1. Operating Environment
Operating temperature
5
d
C to 40
d
C
Performance temperature
10
d
C to 35
d
C
Humidity
10 to 90 % (No condensation)
Weight
Approx. 2.3 kg
(Except the joined-unit and the optional unit and board)
.
To prevent overheating of PFV-L02, ensure that there is
good air circulation around the unit.
.
Do not put the unit in a place subject to excessive lamp
smoke, vapor, moisture, or dust.
c
Install in a stable location.
Installation on unstable or tilting surface may cause the
unit fall off, resulting in injury.
1-2. Supplied Accessories
In the PFV-L02, the following parts used for the mounting
on a rack and the joining two PFV-L02 units are provided.
.
Rack angle (Part No.: 3-203-661-02) ..................... 2 pcs
.
Joint bracket (Part No.: 3-204-705-02) .................. 1 pc
.
Screws (B 4
x
5: 7-682-559-04) .............................. 8 pcs
.
Screws (PS 3
x
6: 7-682-647-09) ............................ 2 pcs
1-3. Power Supply
1-3-1. AC Power Supply
Power voltage
AC 100 V to AC 240 V
Power frequency
50 Hz or 60 Hz
Power consumption
Max. 0.51 A
(With the optional boards installed)
Rush current
AC 100 V IN : 16 A
AC 240 V IN : 20 A
n
The AC power supply requires a capacity which is
commensurate with rush current. If the capacity of the AC power
supply is not sufficient, the breaker of the AC power on the
supply side may operate or this unit may not operate normally.
Recommended Power Cord
For customers in U.S.A. and Canada
Required Parts
1
Power cord, 125 V 10 A (2.4 m) :
!
1-557-377-11
For customers in the United Kingdom
Required Part
2
Power cord, 250 V 10 A (2.5 m) :
!
1-782-929-11
n
For the customers outside of the area shown above, please
contact your local Sony Sales Office/Service Center.
w
.
Use a specified power cord only.
Be sure to use a recommended power cord to avoid fire
and/or an electric shock.
.
Ground the unit for your safety.
Be sure to attach a ground wire to avoid an electric shock.
1-3-2. DC Power Supply
Power voltage
DC 12 V
Power consumption
Max. 1.8 A
m
.
The unit works either on the AC adaptor or battery.
When repairing or checking the unit, AC adaptor
operation is recommended.
.
The AC adaptor AC-DN1 cannot be used to derive power.
.
When the battery is nearly dead, the DC STATUS
indicator on the front panel will blink.
For more details, refer to the Operation Manual supplied
with the unit.
AC inlet
1
2
AC inlet
