23
MZ-NE410/NE410CK
Power Supply Adjustment Auto Item Feed
Note:
This mode is available to perform the temperature correction and
power supply adjustment without entering the manual mode.
• Setting method of power supply adjustment auto item feed mode.
1. Set the test mode (see page 13)
2. Press the
.
key to activate the overall adjustment mode.
3. Press the
[VOL --]
key to set the temperature correction mode.
4. To change the initial value adjust with the
[VOL +]
or
[VOL --]
key.
Press the
ENT/
u
key to write the adjusted value, and the
item number increases automatically.
When not writing the adjusted value, press the
>
key to move
to the next item.
5. Connect a digital voltmeter to the measuring points on the
MAIN board, and adjust the voltage with the
[VOL +]
or
[VOL
--]
key. (see page 18 to 21)
Press the
ENT/
u
key to write the adjusted value, and the item
number increases automatically.
6. When not writing the adjusted value, press the
>
key to
move to the next item. The
.
key is available to back to the
last item.
7. The following message is displayed after all power supply
adjustments finish.
8. Press the
x
/CANCEL
key to return the test mode (display
check mode).
• Configuration of power supply adjustment auto item feed
Set LCD display
A s s y * *
000
Set LCD display
**
: Adjusted value
# # # S * *
015
Set LCD display
**
: Adjusted value
A D * *
741
Set LCD display
A D J O K
000
.
key
>
key
.
key
>
key
.
key
>
key
VOL –
key
000Assy
**
015 ###S
**
741 AD
**
742 AD
**
743 AD
**
.
key
>
key
>
key
>
key
>
key
.
key
>
key
.
key
>
key
749 AD
**
751 AD
**
752 AD
**
753 AD
**
>
key
000 ADJ OK
.
key
.
key
>
key
744 AD
**
745 AD
**
.
key
747 AD
**
748 AD
**
.
key
.
key
>
key
Summary of Contents for MZ-NE410 Notes on installing & operating OpenMG
Page 36: ...36 MZ NE410 NE410CK MEMO ...
