28
Setting Tally
Pre
par
at
ion
c
Set the tally type.
In this example, select [Group1-4] in the <Tally
Group> group, and [R1] and [G1] in the <Tally
Type> group, turning them on.
Turn off [R2] to [R4] and [G2] to [G4] in [Group1-
4], and [R5] to [R8] and [G5] to [G8] in [Group 5-
8].
d
Press [Source Assign].
The Source Assign menu (7367.1) appears.
e
In the <Serial Tally Port> group, select the target
port.
In this example, select [Panel Port].
f
Press [All Clear].
g
Check the message, then press [Yes].
The source addresses assigned to each of the serial
tally bits are set to the default.
If you use other than the default values for serial
tally bits, change the source address settings.
For details about settings, refer to the User’s
Guide.
To output parallel tallies from a DCU, display the
Engineering Setup >Router/Tally >Parallel Tally
menu (7366) in step
3
and make settings.
For details about settings, refer to the User’s Guide.
Input/outputs for MVS-6500 system
assigned to S-Bus matrix
Matrix size: 136 x 138
• Source
Memo
No.
Source
1
Primary 1
2
Primary 2
3
Primary 3
4
Primary 4
5
Primary 5
6
Primary 6
7
Primary 7
8
Primary 8
9
Primary 9
10
Primary 10
11
Primary 11
12
Primary 12
13
Primary 13
14
Primary 14
15
Primary 15
16
Primary 16
17
Primary 17
18
Primary 18
19
Primary 19
20
Primary 20
21
Primary 21
22
Primary 22
23
Primary 23
24
Primary 24
25
Primary 25
26
Primary 26
27
Primary 27
28
Primary 28
29
Primary 29
30
Primary 30
31
Primary 31
32
Primary 32
33
Primary 33
34
Primary 34
35
Primary 35
36
Primary 36
37
Primary 37
38
Primary 38
39
Primary 39
40
Primary 40
41
Primary 41
42
Primary 42
43
Primary 43
44
Primary 44
45
Primary 45
46
Primary 46
47
Primary 47
48
Primary 48
49
50
51
52
53
54
55
56
57
58
59
60
61
No.
Source
