1-5 (E)
MVS-6520
Installation Procedure
1. Turn off the main power of this unit and disconnect the
AC power cord from the wall outlet.
2. Loosen the four screws (with drop-safe) and remove
the front panel in the direction of the arrow.
3. Remove the four fixing screws (B3
x
8) and remove
the Extract PWB stopper assembly.
1-4. Installing the Optional Board
The following options are available for the MVS-6520/6530/3000.
MVS-6520/6530 optional board list
Model name
Board configuration
Plug-in board (Front)
MKS-6550
FC-114 board
Format Converter Board
MKS-6570
DVP-55 board
Digital Multi Effect Board
MVS-3000 optional board list
Model name
Board configuration
Plug-in board (Front)
MKS-6550
FC-114 board
Format Converter Board
1-4-1. Installing the Plug-in Boards
c
Be sure to turn off the POWER switch before starting
installation work.
If installation work is started with the POWER switch left
on, it may cause electrical shock or damage to printed
circuit boards.
In MVS-6520/6530/3000, the slot for installing each
plug-in board is specified. Install each board in the speci-
fied slot correctly according to the indications as described
in
1
and
2
below.
1
The board name is indicated close to the left-of-center
of each plug-in board.
2
The board name is indicated on the right surface of the
inside of front panel of MVS-6520/6530/3000.
m
.
Check to see that connectors of the plug-in boards are
securely inserted into the mother board (MB-1196/1196A
board) without loose contact.
If any plug-in board is inserted into the incorrect slot, it
causes a system error and the system will not work
correctly.
.
After installing the plug-in board, the software must be
installed. Install the software of V8.00 or later version.
For installing the software, refer to the User’s Guide of
the MVS-6520/6530/3000 system.
Front panel
Screws
(with drop-safe)
Screws
(with drop-safe)
PSW
3
x
8
PSW3
x
8
Extract PWB stopper
assembly
