![background image](http://html.mh-extra.com/html/sony/mhc-gt3d/mhc-gt3d_operating-instructions-manual_1330034054.webp)
54
GB
model name [MHC-GT3D]
[4-562-957-
13
(2)] GB
filename[D:\NORM'S JOB\SONY HA\SO150006\MHC-GT3D (PMRF
03)\4562957132_GB (CEK)\090INF.fm]
masterpage:Left
Turn off the system and remove the
USB device. If the USB device has a
power switch, turn the USB device off
and on again after removing it from
the system. Then perform the
transfer again.
If the transfer and erase operations
are repeated multiple times, the file
structure within the USB device
becomes fragmented. Refer to the
operating instructions of the USB
device on how to deal with this
problem.
The USB device was disconnected or
the power was turned off during
transfer. Delete the partially-
transferred file, and perform the
transfer again. If this does not fix the
problem, the USB device may be
broken. Refer to the operating
instructions of the USB device on
how to deal with this problem.
Audio files or folders on the USB
device cannot be erased.
Check if the USB device is write-
protected.
The USB device was disconnected or
the power was turned off during the
erase operation. Delete the partially-
erased file. If this does not fix the
problem, the USB device may be
broken. Refer to the operating
instructions of the USB device on
how to deal with this problem.
There is no sound.
The USB device is not connected
correctly. Turn off the system and
reconnect the USB device, then turn
on the system and check if “USB”
appears in the display panel.
There is noise, skipping, or distorted
sound.
You are using an unsupported USB
device. Check the information on the
website about compatible USB
devices (page 10).
Turn off the system and reconnect
the USB device, then turn on the
system.
The music data itself contains noise,
or the sound is distorted. Noise may
have entered during the transferring
process. Delete the file, and try
transferring again.
The bit rate used when encoding
audio files was low. Send audio files
with higher bit rate to the USB device.
“READING” is displayed for an
extended time, or it takes a long time
before playback starts.
The reading process can take a long
time in the following cases.
There are many folders or files on
the USB device (page 10).
The file structure is extremely
complex.
The memory capacity is excessive.
The internal memory is
fragmented.
“NO FILE” appears in the display
panel.
The system has entered the software
update mode, all buttons (except
) are deactivated. Press
on
the subwoofer to cancel the software
update.
“OVER CURRENT” appears in the
display panel.
A problem has been detected with
the level of electrical current from the
(USB) port. Turn off the system and
remove the USB device from the port.
Make sure there is no problem with
the USB device. If this display pattern
persists, contact your nearest Sony
dealer.
Erroneous display.
The data stored in the USB device
may have been corrupted, perform
the transfer again.