Sony MCC3000MT, Service Manual

Page: 59 / 194

2-16. CN-3534 Board
Preparation
1. Remove the top cover. (Refer to “2-2. Top Cover” . )
2. Remove the RE-309 board. (Refer to “2-12. RE-309 Board” . )
3. Remove the rear panel assembly. (Refer to “2-14. Rear Panel Assembly” . )
Procedure
1. Remove the two screws to detach the CN-3534 board.
2. Remove the DC plate.
3. Disconnect the harness from the connector (CN501) on the CN-3534 board.
PSW3 x 6
CN-3534 board
DC plate
Harness
Bosses
Hole
Hole
Note
When installing the CN-3534 board, fit the two bosses with the two holes.
4. Install the removed parts by reversing the steps of removal.
MCC-3000MT
2-27