Tuner
21
GB
Other Operations
To
Tune in a station with a
weak signal
Stop scanning
Change the preset
number
Change the preset station
Cancel presetting
To change the AM tuning interval
(Except for the Middle Eastern
model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
TUNER ENTER, press
?/1
to turn the system
back on. When you change the interval, all the
AM preset stations will be erased. To reset the
interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for half a day even
if you unplug the power cord or if a power failure
occurs.
• To improve broadcast reception, reorient or move
the supplied antennas near a window or outdoors.
Do this
Follow the procedure
described in “Setting
presets through manual
tuning.”
Press TUNING MODE.
Start over from step 1.
Start over from step 1.
Press TUNER MEMORY.
Listening to the radio
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner's memory first
(see “Presetting radio stations” on page 20).
1
Press TUNER/BAND repeatedly to
select “FM” or “AM.”
2
Press TUNING MODE repeatedly until
“PRESET” appears.
3
Press TUNING –/+ repeatedly to select
the desired preset station.
Tip
You can also select the desired preset station by
pressing PRESET –/+ on the remote after step 1.
Listening to non-preset radio
station
— Manual Tuning
1
Press TUNER/BAND repeatedly to
select “FM” or “AM.”
2
Press TUNING MODE repeatedly until
“MANUAL” appears.
3
Press TUNING –/+ repeatedly to tune in
the desired station.
Tips
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
• When an FM stereo program has static noise, press
FM MODE repeatedly until “MONO” appears.
There will be no stereo effect, but the reception will
improve.
• Press TUNING MODE repeatedly until “AUTO”
appears in step 2 above, then press TUNING –/+.
The frequency indication changes and scanning
stops when the system tunes in a station (Automatic
Tuning).
• To record from the radio, see “Recording to a tape”
on page 23.
Summary of Contents for LBT-XGV10AV
Page 47: ...Additional Information 47GB ...
