— 49 —
KP-46WT500
All capacitors are in µF unless otherwise noted. pF : µµF 50WV or less
are not indicated except for electrolytics and tantalums.
All electrolytics are in 50V unless otherwise specified.
All resistors are in ohms. K=1000, M=1000k
Indication of resistance, which does not have one for rating electrical
power, is as follows:
Pitch : 5mm
Rating electrical power :
1
/
4
W
1
/
4
W in resistance,
1
/
10
W and
1
/
8
W in chip resistance.
: nonflammable resistor.
: fusible resistor.
: internal component.
: panel designation and adjustment for repair.
: earth ground
: earth-chassis
All variable and adjustable resistors have characteristic curve B, unless
otherwise noted.
Readings are taken with a NTSC color-bar signal input.
Readings are taken with a 10M digital multimeter.
Voltages are DC with respect to ground unless otherwise noted.
Voltage variations may be noted due to normal production tolerances.
All voltages are in V.
S : Measurement impossibillity.
: B+ line
: B-line. (Actual measured value may be different).
: signal path. (RF)
Circled numbers are waveform references.
The components identified by
X
in this basic schematic diagram have
been carefully factory-selected for each set in order to satisfy regulations
regarding X-ray radiation. Should replacement be necessary, replace
only with the value originally used.
When replacing components identified by
Y
, make the necessary
adjustments as indicated. If the results do not meet the specified value,
change the component identified by
X
and repeat the adjustment until
the specified value is achieved.
(Refer to Safety-Related Adjustments in Sections 3-1 and 3-2.)
When replacing the parts listed in the table below, it is important to
perform the related adjustments.
� ������
�� ���������
������ ������ ������
������
������ ������ ������
������
�������
������
������ ������ ������
������ ������
������ ������ ������
������ ������ ������
������ ������
����� ������ ����� ������
�� ������ � �����
������
� ������
�� ���� ����
������ ������ ������
������ ������
������ ������ ������
������ ������ ������
������ ������
�������
�������
������ ������
������ ������ ������
������ ������
������ ������
����� ������ ����� ������
�� ������ � �����
������
���� �������� �
�
�
���������� �
�
�
5-1. CIRCUIT BOARDS LOCATION
SECTION 5: DIAGRAMS
5-2. PRINTED WIRING BOARDS AND
SCHEMATIC DIAGRAMS INFORMATION
S
CG
CR
G
A
CB
H2
H4
H1
V
V
D
AD B
U
UD
Summary of Contents for KP-46WT500 - 46" Hi-scan 1080i 16:9 Projection Television
