Sony IPELA SNC-CS10, Service Manual

Page: 8 / 56

1-2
SNC-CS10/CS11
1-4. Removing/Installing the Cabinet
1-4-1. Upper Case Assembly
Removal
1. Remove the lens. (Refer to Section 1-3.)
2. Remove the seven screws, then remove the upper case
assembly.
Installation
3. Attach the upper case assembly.
4. Attach the three screws
1
.
5. Attach the four screws
2
.
1-4-2. Rear Assembly
1. Remove the lens. (Refer to Section 1-3.)
2. Remove the upper case assembly.
(Refer to Section 1-4-1.)
3. Remove the three screws.
4. Disconnect the harness from the connector (CN901)
on the CN-2861 board, then remove the rear assembly.
5. Attach the rear assembly in the reverse order of steps 1
to 4.
1-4-3. Front Assembly
1. Remove the lens. (Refer to Section 1-3.)
2. Remove the upper case assembly.
(Refer to Section 1-4-1.)
3. Remove the screw, then remove the harness (with lug
terminal) from the lower case assembly.
4. Remove the four screws.
5. Remove the dowel
A
of the front chassis from the
hole
A
of the SY-339 board, then remove the front
assembly in the direction of the arrow.
6. Disconnect the flexible flat cable from the connector
(CN101) on the SE-849 board.
7. Attach the front assembly in the reverse order of steps
1 to 6.
2
BSW M2 x 5
1
BSW M2
x
5
1
BSW M2
x
5
2
BSW M2 x 5
Upper case
assembly
BSW M2 x 5
CN901
BSW M2 x 5
Rear assembly
Harness
CN-2861 board
Flexible flat cable
Front chassis
Hole
A
Dowel
A
BSW
M2
x
5
BSW
M2
x
5
CN101
SE-849 board
SY-339 board
Lower case
assembly
Harness
(with lug terminal)
Front assembly
BSW M2 x 5