40
Menu
Setup
(continued)
Recall/Store
Managing the default
values.
Store
Stores the default values set by the user.
User Save:
The current setting values are stored as the user default
values.
Recall
Retrieves the default values.
Factory:
The default values set at the factory are retrieved.
User:
The default values set by the user are retrieved.
Note
If no values have been stored by User Save, the defaults values for
the User and Factory are the same.
Output
Selects the output signal.
FS Process
Selects the action of the frame synchronizer when the signal is
interrupted.
Gray:
The gray picture is output.
Freeze:
The picture just before the signal is interrupted is output.
Format
Selects the output signal format.
720p/59.94:
720 lines, 59.94 Hz, progressive
1080i/50:
1080 lines, 50 Hz, interlaced
1035i/59.94:
1035 lines, 59.94 Hz, interlaced
1080i/59.94:
1080 lines, 59.94 Hz, interlaced
Input
Setting for the input
signal
9Pin Remote
Selects a 9-pin remote control unit.
GPI:
GPI
HKDV-900:
HKDV-900 HD Digital Video Controller
7.5% Setup Remove
Removes the 7.5% setup.
OFF:
Normal conversion is performed.
ON:
Conversion for removing the 7.5% setup is performed.
(This is enabled only when the input signal is an analog NTSC
signal or the D2 (NTSC) signal.)
Ref Input
Selects a signal to be used as a reference signal.
Ref B:
A signal input to the REF IN B connector
Ref A:
A signal input to the REF IN A connector
Input:
An input video signal
Note
If Output Delay is set to Minimum or Adjust, the Ref A and Ref B
buttons are dimmed and cannot be selected.
Ref Format
Selects an external reference signal.
SD:
An SD black burst signal
HD:
An HD three-value signal
Input Video
Selects the input video signal to be up-converted.
Analog:
An NTSC analog signal
D2:
An SDI D2 signal
D1:
An SDI D1 signal
Note
If Format is set to 1080i/50, the Analog and D2 buttons are dimmed
and cannot be selected.
