Sony HDCU1000, Maintenance Manual

Page: 21 / 334

2-1 (E)
MM/HDCU1000 Series
Section 2
Replacement of Main Parts
2-1. Replacing the Main Parts
(HDCU1000/1080)
Be sure to perform the following operation when replacing
or removing the main parts.
.
Turn off the main power and disconnect the plug from
the outlet.
n
Wait for at least three minutes before starting replace-
ment, because even after turning off the power, a high
voltage remains in the machine that could cause electric
shock.
2-1-1. Replacing the Switching Regulator
(HDCU1000/1080)
w
The components marked ! are critical to safe operation. If
you replace with parts other than the specified ones, a fire
or electric shock may result from that.
c
When repairing or replacing the power supply block, set
the voltage. If the voltage is set incorrectly, a fire or
electric shock may result from that.
. When repairing or replacing the power supply block, set
to the same power supply voltage as that of repair work
bench.
.
When delivering to the user, adjust the power supply
voltage to suit the user.
Gently remove or attach the switching regulator holding it
by hand.
Otherwise, the switching regulator may fall, causing an
injury.
Replacement Part
Part : Switching regulator
Part No. :
!
1-468-945-11
1. Remove the front panel.
2. Remove the four screws and remove the flexible card
wire from the connector J8.
3. Remove the PS panel assembly.
4. Disconnect the harnesses from the switching regulator
board connectors J5, J6, and J7.
5. Remove the switching regulator from HDCU1000/
1080 in the direction of the arrow.
J8
PS panel
assembly
Screws
(B4
x 10)
Flexible card wire
(26 strand)
Switching regulator
board
Harnesses
Switching regulator
J7
J5
J6