14
[Aging Mode]
This mode can be used for operation check of CD section and tape deck section.
• If an error occurred:
The aging operation stops and display status.
• If no error occurs:
The aging operation continues repeatedly.
1.
Operating method of Aging Mode
Turn on the main power and select “CD” of the function.
1) Set a disc in DISC1 tray. Select CONTINUE ALL DISCS (press the PLAY MODE button),
and REPEAT OFF (press the REPEAT button).
2) Load the tapes recording use into the decks A and B respectively.
3) Press three buttons
x
, ENTER , and
DISC SKIP/EX-CHANGE simultaneously.
4) Aging operations of CD and tape are started at the same time.
5) To exit the aging mode, perform [MC Cold Reset].
3. Aging Mode in CD section
1) Display state
• No error occurs
Note:
[*][*][*][*]
: Number of aging operations
Error display
E
**
s
## $$ %%
1 2 3 4 5
• When the buttons
x
, ENTER and DISC 1 are pressed simultaneously, number of time of the mechanism error and the NO DISC
error can be checked.
Display:
EMC**EDC**
**
:
Number of times of error (Maximum three times)
EMC: Mechanism error
EDC: NO DISC error
• When aging operation is complete, be sure to perform the MC Cold Reset to reset the error history.
D: No disc error
01: FOCUS ERROR
02: GFS ERROR
03: SETUP ERROR
01: NO DISC judgment without chucking retry
02: NO DISC judgment after chucking retry
Status at the time of NO DISC judgment
(High order digits only)
1:
STOP
2:
SETUP
3:
TOC READ
4:
ACCESS
5:
PLAY BACK
6:
PAUSE
7:
MANUAL SEARCH (PLAY)
8:
MANUAL SEARCH (PAUSE)
AGING
[*][*][*][*]
1
**
2
s
3
##
4
$$
5
%%
M: Mechanism error
Don’t care
High order digits only
D: Stopped during closing due to problems other than mechanism.
E: Stopped during opening due to problems other than mechanism.
C: Stopped during chucking due to problems other than mechanism.
F: Stopped during EX-opening due to problems other than mechanism.
Emergency related errors (High order digits only)
1:
Stopped during chuck-up
2:
Stopped during chuck-down
3:
Time out by EX-OPEN
5:
Time out by EX-CLOSE
The error No. 00 indicates the newest error. As the error No. increases, it means the older error.
When you want to retrieve the error history, press the PLAY MODE button in the case of mechanism error.
Or press the REPEAT button in the case of NO DISC error.
Display