Sony HCD-SHAKE7, Service Manual, Page: 12 / 92

HCD-SHAKE7
12
8 four insulator screws
7
connector
qa
insulator
6
belt
3
Insert the thin
wire (clip etc.).
5
tray
qs
service,
optical device
qa
insulator
qa insulator
qh
qk wire (flat type)
(24 core)
1
six claws
4
9
0
2
chuck holder assy (T)
2 Solder the short-land.
qg wire (flat type)
(5 core)
– Bottom view –
loading assy (T)
qd base, lo assy
qf
tape
qj
holder, FFC
Note 2:
When assembling the optical pick-up block,
remove the solder of short-land after
connecting the wire (flat type) (24 core).
2-8. SERVICE OPTICAL DEVICE, WIRE (FLAT TYPE)
Under the guide
Under the guide
(Fold area)
Fold
‡,QVWDOODWLRQRIZLUHIODWW\SHFRUHDQGZLUHIODWW\SHFRUH
Note:
This illustration sees the loading assy (T) from bottom side.
1
wire (flat type) (24 core)
2
Through the hole
3
Through the hole
4
terminal face
loading assy (T)
7
wire (flat type) (24 core)
6 holder, FFC
5
three claws
5 two claws
8
wire (flat type)
(5 core)
9
tape
Note 1 : Before disconnecting the wire (
fl
at type) (24 core) of optical pick-up block, solder the short-land.