![background image](http://html.mh-extra.com/html/sony/hcd-rg190/hcd-rg190_service-manual_420841019.webp)
19
HCD-RG190/RG290
CD SECTION
Note:
1.
CD Block is basically constructed to operate without adjustment.
2.
Use YEDS-18 disc (3-702-101-01) unless otherwise indicated.
3.
Use an oscilloscope with more than 10 M
Ω
impedance.
4.
Clean the object lens by an applicator with neutral detergent when the
signal level is low than specified value with the following checks.
5.
Check the focus bias check when optical pick-up block is replaced.
•
Abbreviation
MX: Mexican model
FOCUS BIAS CHECK
Procedure :
1. Connect oscilloscope to TP (RFACI) and TP (VC) on the CD
board (Except RG290: MX) or BD board (RG290: MX).
2. Press the
I/
1
button to turn the power on, and press
the
A
button to open the CD disc table.
3. Set disc (YEDS-18) on the tray and press the
7
button to
playback.
4. Confirm that oscilloscope waveform is as shown in the figure
below. (eye pattern)
A good eye pattern means that the diamond shape (
◊
) in the
center of the waveform can be clearly distinguished.
Connecting Location:
+
–
CD board (Except RG290: MX)
BD board (RG290: MX)
TP (RFACI)
TP (VC)
oscilloscope
(DC range)
VOLT/DIV: 200 mV
TIME/DIV: 500 ns
level:
0.9
±
0.4 Vp-p
TP
(VC)
TP
(RFACI)
IC201
– CD Board (Conductor Side) (Except RG290: MX) –
TP
(VC)
TP
(RFACI)
IC201
– BD Board (Conductor Side) (RG290: MX) –
Summary of Contents for HCD-RG190
Page 20: ...20 HCD RG190 RG290 MEMO ...
Page 125: ...19 HCD RG190 RG290 MEMO ...