8
Cold Reset
• The cold reset clears all data inculuding preset data stored in the RAM to initial conditions. Execute this mode when returning the set to the
customer.
Procedure 1: (recommended)
Press the RESET button on the back panel.
Procedure 2:
1. When the power ON, press the
1
/
u
button while pressing the PLAY MODE/TUNING MODE button and
p
(CD) buttons together.
2. “COLD RESET” is displayed on the fluorescent indicator tube and reset is executed.
Hot Reset
• This mode reset the preset data kept in the memory. The hot reset mode functions same as if the power cord is plugged in and out.
Procedure :
1. When the power ON, press the
1
/
u
button while pressing the PLAY MODE/TUNING MODE button and
^
(CD) buttons together.
2. Turn off the unit and reset is executed.
LED and Fluorescent Indicator Tube All Lit, Key Check Mode
Procedure :
1. When the power ON, press the
1
/
u
button while pressing the PLAY MODE/TUNING MODE button and
6
(CD) buttons together.
2. LEDs and fluorescent indicator tube are all turned on.
3. Press
^
(MD) button to turn set on.
4. In the key check mode, the fluorescent indicator tube displays “Key 0 Vol 0”. Each time a button is pressed, “Key” value increases.
However, once a button is pressed, it is no longer taken into account.
“Vol” Value increases like “1, 2, 3 ...” if rotating VOLUME knob in the clockwise direction, or decreases like “0, 9, 8 ...” if rotating in the
counterclockwise diretion.
5. To exit from this mode, press three buttons in the same procedure as step 1, or disconnect the power cord.
Note:
Press the
=0
/MD/CD/TUNING– button or
)+
/MD/CD/ button for more than 1 second.
Change-over of AM tuner Step between 9kHz and 10kHz.
• A step of AM channels can be changed over between 9kHz and 10kHz.
1. Press
1
/
u
button to turn set on.
2. Select the function “TUNER”, and press TUNER/BAND button to select the BAND “AM”.
3. Press
1
/
u
button to turn on the set OFF.
4. When the power OFF, press
1
/
u
button while pressing the PLAY MODE/TUNING MODE button.
The display of fluorescent indicator tube changes to “AM 9k STEP” or “AM 10k STEP”, and thus the channel step is changed over.
CD Text Display
• This unit displays CD text.
Text is displayed for the first 50 track only and will not be displayed from the 51st track onwards. Do not suspect a fault in this case.
In some cases, some special characters will not be displayed and may be replaced by other characters. Donot suspect a fault in this case.
Summary of Contents for HCD-MD373
