![Sony HCD-DX375 Service Manual Download Page 33](http://html.mh-extra.com/html/sony/hcd-dx375/hcd-dx375_service-manual_416365033.webp)
33
33
HCD-DX375
HCD-DX375
• Circuit Boards Location
FL board
JACK board
POWER board
LED board
SW board
I/O board
SPEAKER board
MAIN board
HEATSINK (A) board
DMB12 board
HEATSINK (B) board
TUNER UNIT
SECTION 6
DIAGRAMS
For Schematic Diagrams.
Note:
• All capacitors are in
µ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
•
C
: panel designation.
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
•
A
: B+ Line.
• Voltages and waveforms are dc with respect to ground un-
der no-signal (detuned) conditions.
• Voltages and waveforms are dc with respect to ground in
service mode.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
no mark : DVD STOP
*
: Impossible to measure
• Voltages are taken with VOM (Input impedance 10 M
Ω
).
• Circled numbers refer to waveforms.
• Signal path.
F
: AUDIO
J
: CD PLAY
c
: DVD PLAY
I
: SACD PLAY
d
: TUNER
L
: VIDEO
E
: Y
a
: CHROMA
r
: COMPONENT VIDEO
f
: AUDIO IN
For Printed Wiring Boards.
Note:
•
X
: parts extracted from the component side.
•
a
: Through hole.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
• Indication of transistor.
Caution:
Parts face side: Parts on the parts face side seen from
(SIDE A) the parts face are indicated.
Pattern face side: Parts on the pattern face side seen from
(SIDE B) the pattern face are indicated.
✩
New part of EEP ROM (IC103, IC706) on the DMB12 board
cannot be used. Therefore, if the mounted DMB12 board
(A-1148-813-A) is replaced, exchange new EEP ROM
(IC103, IC706) with that used before the replacement.
Note: The components identified by mark
0
or dotted
line with mark
0
are critical for safety.
Replace only with part number specified.
C E
B
These are omitted
C
B
These are omitted.
E
Q
Summary of Contents for HCD-DX375
Page 103: ...103 HCD DX375 MEMO ...