NAC-HD1E.GB.3-213-271-11(1)
101
GB
The contents recorded by the
Recording Timer is not complete. Some
of the material at the beginning or in
the middle are missing.
Set the date and time correctly (pages 18
and 69).
A power failure occurred while the timer
setting was in standby mode or the power
cord was disconnected.
You performed an operation, such as an
editing operation, or you backed up the
data shortly before the Recording Timer
was activated.
The unit was subjected to shocks or
vibrations. Place the unit at a stable
location.
Network Media
You cannot connect to the server
(the message “Cannot access server.”
appears).
Make sure the network cable is
connected.
If a hub or a router with a built-in hub
is being used, make sure that it is turned
on.
Make sure the server is turned on.
Make sure that the IP address of this unit
is correctly obtained.
If [DHCP] is set to [All auto] and the
IP address is obtained correctly, the IP
address will appear in the display (page
89). If the IP address does not appear,
check the following items.
Make sure the hub or broadband
router is turned on. (Refer to the
operating manuals supplied with the
equipments being used.)
Make sure the broadband router is
turned on before you turn on the unit.
Make sure network cables are being
used to connect the unit, hub, or
broadband router (pages 83 to 86).
Make sure that the method of
obtaining the IP address is correct for
your network environment (page 89).
Check that the initial settings for the
server have been correctly made.
If the ICF (Internet Connection Firewall)
function is active in the server, this may
prevent the unit from connecting to the
server. In this case, deactivate the ICF
function.
Make sure the registration of the unit has
been correctly made on the server side.
Even if you erase the registration of the
unit from the server, the server may
appear in the selectable server list of this
unit.
Register the unit in the server again.
If you cannot connect the unit to the
server using the NETWORK MEDIA
function even if all settings have been
correctly made, restart the server.
If you changed the network connection
from wired to wireless, or vice-versa, the
access limitation setting will be lost. In
this case, do the access limitation setting
again.
The unit does not connect
automatically to the server.
If the unit is directly connected to the
server with a cross cable, the unit may
not be able to connect to the server. Make
sure the unit is connected to the server
through a hub.
Continued
