Sony DynaView SSC-DC593, Service Manual

Page: 22 / 72

3-4
SSC-DC593/DC593P/DC598P (E)
3-2-2. Writing of Initial Data
Usually, the writing of initial data is automatically
performed when it is required. It can also be performed by
the following method.
1. Press the START/STOP button on top of the
commander.
2. The number displayed on the LCD of the commander
disappears for several seconds and is displayed again.
n
In case that the number on the LCD is not displayed again,
something is wrong with the circuit. After repairing the
circuit, make adjustment.
Be sure to confirm the following after performing the
initial data writing.
1. Change the mode display to “5F” by pressing the
mode display button of the commander.
2. Change the data display to “01” by pressing the data
change button.
3. Confirm the data according to the following table as
steps 1 and 2.
When the data is not correct, change the data.
Mode Data
4C 90 (SSC-DC593)
A0 (SSC-DC593P/DC598P)
4D 60 (SSC-DC593)
A0 (SSC-DC593P/DC598P)
4. After completing all changes of the above data, write
the data by pressing the data writing button of the
commander.
The LCD display of the commander disappears for
several seconds and is displayed again.
3-3. Camera Adjustment
3-3-1. Adjusting Mode Setting
1. Press the Adjusting mode setting button of the
commander.
2. The number displayed on the LCD of the commander
disappears for several seconds and is displayed again.
Subject: Not required
Measuring point: None
3-3-2. fsc Adjustment
1. Press the step forward button of the commander one
time. Then, “24” appears on the mode display.
2. Press the data change button so that the measuring
frequency is within the specification.
Subject: Not required
Measuring point: PR-269 board, TP202
Measuring equipment: Frequency counter
Mode display: 24
Specification: 14.318181
±
0.000080 MHz
(SSC-DC593)
17.734472
±
0.000080 MHz
(SSC-DC593P/DC598P)
PR-269 board (Side A)
TP202
IC304
CN202