72
Controlling Your TV or AV
Amplifier (Receiver) With
the Supplied Remote
By adjusting the remote signal, you can
control your TV with the supplied remote.
If you connect the player to an AV amplifier
(receiver), you can control the volume with
the supplied remote.
Notes
• Depending on the connected unit, you may not be
able to correctly control your TV or AV amplifier
(receiver) using some of the buttons below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the
code number you have set may be reset to the
default setting. Set the appropriate code number
again.
Controlling TVs with the remote
1
Slide the TV/DVD switch to TV.
2
While holding down
[
/
1
, press down
on the scroll key.
“TV P-1” (default) appears in the LCD
screen.
3
Release
[
/
1
.
4
Toggle the scroll key up or down to
select your TV’s manufacturer code
(see “Code numbers of controllable
TVs” below).
5
Press down on the scroll key.
The manufacturer code flashes and the
remote is set.
When the TV/DVD switch is set to TV,
the remote performs the following:
* If you use number buttons to select the TV’s
programme position, press -/-- followed by the
number buttons for two-digit numbers.
** If you connect the player to the TV via the
SCART (EURO AV) jacks, the input source for
the TV is set to the player automatically when
you start playback or press any button except for
[
/
1
. In this case, press TV/DVD to return the
input to the TV.
[
/
1
2
+/–
t
Number
buttons, -/--
TV/DVD
switch
Scroll key
PROG +/–
TV/DVD
[
/
1
Turns the TV on or off
2
(volume) +/– Adjusts the volume of the TV
(wide mode) Switches to or from the wide
mode of a wide TV
t
(TV/video)
Switches the TV’s input
source between the TV and
other input sources
PROG +/–,
number buttons,
and -/--*
Selects the programme
position of the TV
TV/DVD**
Switches the TV’s input
source between the TV and
player (point the remote at
the DVD player)
The button works even if
the TV/DVD switch is set to
DVD.
