DSX-GS900
5
Sony CONFIDENTIAL
For Authorized Servicer
CONFIRMATION OF DESTINATION SETTING CODE
When replacing the MAIN board, perform works according to the
following procedure.
If the correct destination code is not displayed, it is necessary to set
the destination.
Procedure:
1. After replacing the MAIN board, assemble the main unit to the
normal condition, and connect the regulated DC power supply.
+
–
Regulated DC
power supply
2. Press and hold the [ OFF SRC] button to the state of source off
(the clock is displayed on the liquid crystal display), enter the
test mode by pressing the buttons in order of the [ 4]
→
[MIC
5]
→
[
u
6] (press only the [
u
6] button for 2 seconds) and
display the software main version.
(Displayed characters/values in the following
fi
gure are exam-
ple)
[ 4]
press
[MIC 5]
press
Software main version
[
u
6]
press for
2 seconds
3. In the state in which the software main version is displayed
on the liquid crystal display, enter the destination code display
mode by pressing the [ SCRL DSPL] button 3 times.
(Displayed characters/values in the following
fi
gure are exam-
ple)
Software main version
Destination code
(Not used for the servicing)
[ SCRL DSPL]
press
Set to this state
of display.
Bluetooth adress (1/2)
Bluetooth adress (2/2)
4. Con
fi
rm the alphanumeric character of 6 digits on the liquid
crystal display is a value of “728332”.
Note:
If “728332” is not displayed or another alphanumeric character is dis-
played, perform “DESTINATION SETTING METHOD” on page 6.
Destination code
OP0
OP1
OP2
OP3
OP4
OP5
6 digits
5. Press the [ OFF SRC] button for 1 second or more to execute
reset and return to the normal condition.
[ OFF SRC] press
for 1 second or more
6. This completes the destination check work.
SYS SET
2019/10/17 22:00:30 (GMT+09:00)