Chapter 5
Editing
Chapter 5
Editing
5-9
The following figure illustrates this.
In CONFI mode, you can monitor the video and audio
signals actually recorded. You can use CONFI head
playback for the whole edit operation from the preroll
point to the postroll point, including the section
between the IN and OUT points.
Using a single monitor for video and audio
on both player and recorder
For efficient editing if only one monitor is available,
use the following method.
1
Connect the monitor to the recorder.
2
In the setup menus, set item 008 to “AUTO”.
3
Press the PLAYER button on the recorder.
This forces the recorder to E-E mode, in which the
player video and audio signals are output to the
monitor.
Note
In insert editing, a CTL signal must be recorded on
the recorder tape. It is not possible to carry out editing
on a section of the tape with no CTL signal.
Starting automatic editing
When you have set the edit points, press the flashing
AUTO EDIT button.
The AUTO EDIT button changes from flashing to
continuously lit, and the automatic editing operation
begins.
At the end of the editing operation, the AUTO EDIT
button goes off.
To change the OUT point after starting
automatic editing operation
After starting the automatic editing operation, to end
the operation before the preset OUT point, hold down
the ENTRY button and press the OUT button.
The position where you pressed the button becomes
the OUT point, and editing ends.
To abandon automatic editing
Press the STOP button.
The automatic editing operation is abandoned. At the
same time, the PREVIEW button and AUTO EDIT
button start flashing, and the state before the editing
was started is restored.
In this case, the IN and OUT points already set are
preserved so that you can carry out a preview or
automatic editing operation again by pressing the
PREVIEW button or AUTO EDIT button.
Reviewing the editing results
After carrying out an editing operation, you can carry
out a review, to check the editing results on the
monitor.
To carry out a review, after carrying out the edit, and
before you set any new edit points or make other
settings, press the REVIEW button.
The REVIEW button lights, and the review is carried
out.
At the end of the review the REVIEW button goes off,
and the tape returns to the OUT point.
After automatic editing, to adjust the edit
points and reexecute the edit
Hold down the DELETE button and press the ENTRY
button to recall the edit points. After adjusting the edit
points, press the AUTO EDIT button to carry out the
edit again.
For details of how to adjust edit points, see Section 5-1-5,
“Modifying and Deleting Edit Points” (page 5-6).
IN point
OUT point
Playback
(recorder)
E-E mode
(player)
Playback
(recorder)
9
)
0
6
p
%
PREVIEW button
ENTRY button
OUT button
AUTO EDIT button
REVIEW button