5-24
DCR-IP5/IP5E/IP7BT/IP7E
13. Color Reproduction Adjustment
Adjust the color Separation matrix coefficient so that proper color
reproduction is produced.
Subject
Color bar chart
(Color reproduction adjustment frame)
Measurement Point
Video output of A/V jack
Measuring Instrument
Vectorscope
Adjustment Page
F
Adjustment Address
35, 37, 3C, 3D
Specified Value
All color luminance points should settle
within each color reproduction frame.
Note1:
This adjustment should be carried out upon completion of the LV
standard data input.
Note2:
NTSC model: DCR-IP5/IP7BT
PAL model: DCR-IP5E/IP7E
Switch setting:
1)
POWER .................................................................. CAMERA
2)
DIGITAL ZOOM (Menu display) ................................... OFF
3)
STEADY SHOT (Menu display) ..................................... OFF
Adjusting method:
1)
Select page: 0, address: 01, and set data: 01.
2)
Select page: F, address: 8E, set data: 29, and press the PAUSE
button.
3)
Select page: F, address: C0, set the following data and press
the PAUSE button.
37: NTSC model
B7: PAL model
4)
Select page: 6, address: 01, set data: 3D, and press the PAUSE
button.
5)
Adjust the GAIN and PHASE of the vectorscope, and adjust
the burst luminance point to the burst position of the color
reproduction frame.
6)
Change the data of page: F, address: 35, 37, 3C and 3D, and
settle each color luminance point in each color reproduction
frame.
Note:
Be sure to press the PAUSE button before changing the
addresses. If not, the new data will not be written to the memory.
Processing after Completing Adjustments:
1)
Select page: F, address: 8E, set data: 2E, and press the PAUSE
button.
2)
Select page: 6, address: 01, set data: 00, and press the PAUSE
button.
3)
Select page: 0, address: 01, and set data: 00.
Burst position
For NTSC model
Burst position
For PAL model
Fig. 5-1-12.
