2-5
DSC-W1/W12
2-3. EXCHANGE METHOD OF BARRIER ASSY
Service parts
Part Number
Part Name
Quantity
1
3-091-427-01
Ring (A), Ornamental
1
2
X-3954-476-1
Barrier Assy
1
3
3-086-156-31
Tapping screw (P2)
2
Tools used
Torque driver
Soldering iron
Weight about 60g
Adhesive (Super X) (Note)
Note:
Use adhesive (Super X) or an equivalent article.
Don’t use what becomes white after drying like a quick-drying glue.
2-3-1. PEEL OFF OLD ORNAMENTAL RING A
The Ornamental Ring A has adhered to the Barrier Assy strongly and accordingly, use a soldering iron to weaken the adhesive force.
Heat four circled portions with the soldering iron.
Heating temperature is about 300ºC.
Beware of a burn since the entire Ornamental Ring becomes hot.
*
As the adhesive force of Ornamental Ring A is considerably large, the forced peeling will damage the group-1 frame.
Insert the tip of tweezers, etc. into a notch of the group-1 frame and prize the ring.
*
Take extreme care so as not to damage the coated surface of the group-1 frame.
In case of difficult peeling, heat the ring again with the soldering iron.
If this re-heating failed, it may be advisable that the ring be peeled while heating the portions
1
→
2
→
3
→
4
in the under figure one
by one sequentially.
*
Discard the removed Ornamental Ring A.
1
2
3
1
Tip
3
4
2
