![background image](http://html.mh-extra.com/html/sony/cmt-md1-micro-hi-fi-component-system/cmt-md1-micro-hi-fi-component-system_operating-instructions-manual_420409006.webp)
6
Step 1: Hooking up the system
(continued)
7
Connect the power cord to a wall
outlet.
If the plug of the power cord does not fit
your wall outlet, detach the supplied
adaptor from the plug (only for models
equipped with an adaptor).
8
To use the remote, pull out the
insulating sheet to allow power to
flow from the battey.
The remote already contains a battery.
6
Turn the system upside down
holding the disc door with firm
hand and set the speaker cord into a
groove at the bottom of the system.
Note on the glass over the display
The glass over the display window on the cover
of the CMT-MD1/MD1DX is made of tempered
glass. Under normal conditions, this tempered
glass is more shock resistant and able to bear
more weight than ordinary glass. This glass,
however, may shatter if it receives a sharp blow
or if it is scratched.
To detach the speakers (For CMT-MD1
only)
1
Slide the speakers in the opposite direction
of the arrows of the illustration in “Attach
the speakers” (see step
2
-
3
on page 5.)
2
After detaching the speakers, set the
speaker cords into the speaker cord groove
at the bottom of the speaker. Otherwise,
the speaker cord could be damaged.
Groove
Tip (CMT-MD1 only)
When using the system with the speakers detached,
you may remove the four screws on both sides of
the system. If you do, be sure to retain the screws
for future use.
Note (CMT-MD1 only)
Do not attempt to lift up the system by the speakers.
There is a chance the system will detach and drop.
To move the system, detach the speakers first and
carry them separately.
On placement
The system is equipped with a cooling fan on the
rear panel. Do not block the rear and side
ventholes. Keep a distance of 10 cm (4 in) or more
between the back of the system and wall.
Summary of Contents for CMT-MD1 - Micro Hi Fi Component System
Page 61: ...61 Additional Information ...