![background image](http://html.mh-extra.com/html/sony/cmt-md1-micro-hi-fi-component-system/cmt-md1-micro-hi-fi-component-system_operating-instructions-manual_420409036.webp)
36
Making a space
between tracks 3
seconds long
–– Smart Space, Auto Cut
To cancel automatic track marking
1
Press EDIT on the remote during recording
pause.
2
Press +/– on the remote repeatedly until
“LevelSync ?” appears.
3
Press ENTER/YES on the remote.
“LevelSyncOFF?” appears.
4
Press ENTER/YES on the remote again.
“LEVEL-SYNC” disappears.
When “LEVEL-SYNC” disappears, a track
number is marked only at the beginning of
each recording.
Notes
• You may not mark track numbers automatically if
the sound source to be recorded is noisy (e.g.,
tapes or radio programs).
• The MD recording is complete only after all the
recording information is entered to TOC at which
point TOC stops flashing and goes out. Be careful
not to disconnect the power cord or move the
system before this point. Before disconnecting the
power cord, do the following:
– Remove the MD.
– Press
1/u
to turn off the system.
Marking track numbers
at a specific point while
recording
–– Track Mark
You can mark track numbers at any time
while recording, regardless of the type of
sound source.
The Smart Space and Auto Cut functions let
you make a blank space between tracks three
seconds long automatically while making a
digital recording.
Smart Space
If there is extended silence of 4 to 29 seconds
while digital recording, the system replaces
the silence with a blank of about 3 seconds
and continues recording.
Auto Cut
If there is no sound input for 30 seconds
while digital recording, the system replaces
the silence of 30 seconds with a blank of
about 3 seconds and enters recording pause.
Notes
• The Smart Space and Auto Cut functions are
factory set to ON.
• If you turn the power off or disconnect the power
cord, the system will recall the last setting (ON or
OFF) of the Smart Space and Auto Cut functions
the next time you turn the power on.
• The MD recording is complete only after all the
recording information is entered to TOC at which
point TOC stops flashing and goes out. Be careful
not to disconnect the power cord or move the
system before this point. Before disconnecting the
power cord, do the following:
– Remove the MD.
– Press
1/u
to turn off the system.
Marking track numbers
(continued)
Press REC while recording at the point
you want to add a track mark.
The tracks following the added one are
numbered.
(P
1/u
=
0
–
p
)
+
+
(P
p
+
–
6
REC
Summary of Contents for CMT-MD1 - Micro Hi Fi Component System
Page 61: ...61 Additional Information ...