10
6
Press +/– repeatedly to select the preset
number that you want.
3 1 0 0 5
7
Press ENTER.
The station is stored to the selected preset
number.
8
Repeat steps 2 through 7 to preset other
stations.
To tune in a weak station
In step 3, press TUNING MODE repeatedly until
“MANUAL” appears, then press +/– repeatedly to
tune in the station.
To change the preset number
Start over from step 2.
Tip
The preset stations are saved in the system’s memory
for about two days even if you disconnect the power
cord or a power failure occurs.
To change the AM tuning
interval (not applicable on the
European model)
The AM tuning interval is factory-preset to 9 kHz (or
10 kHz on North American model). To switch the
AM tuning interval, tune in any AM station first, then
turn off the system. Pressing on the unit
down, turn the system back on. When you change the
interval, all the AM preset stations are erased. To
change back to the original interval, repeat the same
procedure.
Connecting optional
components
This section explains how to connect a variety of
components to your system in order to enhance it.
Refer to the instructions included with each
component for details.
Connecting audio components
Connecting an MD deck for
analog recording
You can connect an MD deck to the system with
commercially available audio cords. Be sure to
match the color-coded pins to the appropriate
jacks. To listen to the MD deck after connecting it,
press FUNCTION repeatedly until “MD” appears.
To the audio output jacks on
the MD deck
To the audio input jacks on the MD
deck
Step 3: Presetting radio stations
(continued)
