1-5 (E)
CBK-MB01
1-5. Removing and Installing the DVP Board Assembly
1-5. Removing and Installing the DVP
Board Assembly
Removal
1.
Open the inside panel assembly. (Refer to Section 1-3.)
2.
Remove the DCP board assembly. (Refer to Section 1-4.)
3.
Disconnect the flexible card wire from the EQ-88
board connector (CN101).
m
.
Life of flexible card wire will be significantly
shortened if it is folded. Be very careful not to fold
the flexible card wire.
.
If the copper plating of the base material exposes
due to wear of the tin plated contact of the connec-
tor, replace it with the new flexible card wire.
CN101
EQ-88 board
Flexible card wire
4.
Open the board lever in the direction of arrow A and
remove the board-to-board connector that is connected
to the MB-1032 board.
5.
Raise the DVP board assembly in the direction of arrow
B by about 15 mm and align the protruded portion of the
board holder (F) with the recessed portion of the DVP-
34 board.
6.
Slant the DVP board assembly to the front and remove it.
A
A
B
MB-1032 board
DVP board
assembly
Board lever
Board lever
Board-to-board
connectors
Recessed
portion of
the DVP
board
assembly
Protruded
portion of
the board
holder (F)
DVP board
assembly
