1-3 (E)
CBK-MB01
1-4. Removing and Installing the DCP Board Assembly
1-4. Removing and Installing the DCP
Board Assembly
Removal
1.
Open the inside panel assembly. (Refer to Section 1-3.)
2.
Disconnect the coaxial cable from the connector
(CN10) of the DCP-38 board. (When the CBK-SD01
is installed, disconnect the coaxial cable from the
connector (CN1) of the DIF-147 board.)
n
To disconnect the coaxial cable, do not attempt to
disconnect it by pulling the coaxial cable with force.
Be sure to hold the plug and disconnect the cable.
3.
Remove the screw (B2.6
x
5) and the filter cover.
4.
Disconnect the board-to-board connector that comes
from the DCP-38 board, and open the CN-2437 board
in the direction of the arrow.
B2.6
x
5
OK
NG
Coaxial cable
CN-2437
board
DCP-38
board
CN10
CN-2437 board
Board to
board connector
DCP-38 board
Hold the plug
to remove
Do not attempt to
remove by pulling
the plug.
Filter cover
5.
Remove the harnesses from the connectors (CN1, CN3
and CN4) of the VA-228 board.
6.
Remove the two screws (B2.6
x
5).
7.
Open the board lever in the direction of arrow A, and
disconnect the board-to-board connector that is
connected to the MB-1032 board.
8.
Raise the DCP board assembly about 10 mm in the
direction of arrow B, and align the recessed portion of
the DCP-38 board with the protruded portion of the
board holder.
CN4
CN3
CN1
B2.6 x 5
VA-228 board
VA-228 board
Harness
A
B
A
MB-1032 board
DCP board assembly
DCP board
assembly
Recessed
portion
Board-to-board
connector
Board holder
Board
holder
Board lever
