Sony Cablevision DHG-M55CV, Hardware Setup Instructions

Page: 32 / 38

Other Information
26
Changing the Digital
Network Receiver’s
RF Output Channel
If you connected the Digital Network Receiver to your TV or VCR
using an RF connection (as described on pages 16 and 18), you need
to set the RF output channel of the Digital Network Receiver to match
the RF channel (channel 3 or 4) of the cable service provided in your
area. The Digital Network Receiver is shipped with its RF output
channel set to channel 3.
To set the RF output channel of the Digital Network Receiver
1
Using the buttons on the front panel, first press the
STANDBY 1
button to turn off the Digital Network Receiver, which puts the
unit in standby mode.
2
To set the Digital Network Receiver to channel 3 or 4:
3
Do one of the following:
❑
If you connected the Digital Network Receiver to your TV (as
described on page 16), tune your TV to channel 3 to see cable
channels.
❑
If you connected the Digital Network Receiver to your VCR
(as described on page 17), set your VCR’s RF channel switch
(usually on the rear panel) to channel 3 to see cable channels.
To Use RF Press These Front Panel Buttons Sequentially
Channel 3
F
(cursor up),
g
(cursor right),
f
(cursor down)
Channel 4
F
(cursor up),
g
(cursor right),
F
(cursor up)
CV.book Page 26 Thursday, November 30, 2000 2:13 PM