Ov
er
v
ie
w
Location and Function of Parts
20
N
VISCA RS-232C IN connector
Connect to the RM-BR300 Remote Control Unit
(not supplied). When you connect multiple
cameras, connect it to the VISCA RS-232C OUT
connector of the previous camera in the daisy chain
connection.
O
VISCA RS-232C OUT connector
When you connect multiple cameras, connect it to
the VISCA RS-232C IN connector of the next
camera in the daisy chain connection.
P
S VIDEO connector
Outputs the camera images as S video signal.
Q
T
VIDEO connector
Outputs the camera images as composite video
signal.
R
Card slot
Insert the optional BRBK-SF1, BRBK-HD2,
BRBK-HSD2, or BRBK-SA1 Output Card.
The slot cover is attached to the camera at the
factory.
S
RGB/COMPONENT connector
Supplies the images as analog component (YPbPr
or RGB) signal.
Bottom
T
Ceiling bracket mounting screw holes
When you install the camera to the ceiling or on a
shelf, etc. in a high position, secure the supplied
ceiling bracket to these holes using the supplied
four screws. The four feet are attached to the holes
at the factory.
For installation, see “Installing the Camera in a
High Position” on page 55.
U
Tripod screw holes (1/4-20UNC)
When you install the camera to a tripod, secure the
tripod to these holes.
V
BOTTOM switches
Used for the output signal format selection, RS-
232C/RS-422 selection, baud rate selection, remote
control signal output on/off and camera address
setting.
For details, see “Setting of the BOTTOM switches”
on page 20.
Setting of the BOTTOM switches
1
Switch 1 (59.94/50 signal format selector)
Set to ON for output in 1080/50i (720/50p) signal
format, OFF for output in 1080/59.94i (720/59.94p)
signal format.
2
Switch 2 (1080i/720p signal format selector)
Set to ON for output in 720p signal format, OFF for
output in 1080i signal format.
3
Switch 3 (RS-232C/RS-422 selector)
Set to ON for RS-422, or OFF for RS-232C.
When you are using a BRBK-SF1 HD Optical
Multiplex Card, this switch setting is disabled.
4
Switch 4 (Communication baud rate selector)
Set to ON for 38400 bps, or OFF for 9600 bps.
When you are using a BRBK-SF1 HD Optical
Multiplex Card, this switch setting is disabled.
5
Switches 5-7 (Camera address selector)
Set the address of the camera.
Normally set to “0”. With this setting, addresses are
assigned to the cameras automatically in the
connected order by pressing the POWER button
while holding down the RESET button on the RM-
BR300 Remote Control Unit.
When you are using a BRBK-SF1 HD Optical
Multiplex Card, this switch setting is disabled.
You can assign the camera address “1” to “7”
manually by setting these selectors as follows:
wa
w;
ws
O
N
1
2
3
4
5
6
7
8
9
10
1
B
2
1
4
5
7
3
6
