Sony BKSI-2010, Installation Manual

Page: 8 / 28

1-4(E)
BKSI-2010
2. Information of BKSI-2010
2-2. Connector Panel Installation
General information for installation
• The connector panel is inserted into the slot with the
same number as the plug-in board installed in the front
of SIU-80.
• The model label supplied with the BKSI-2010 is at-
tached in the chassis to prevent the panel inserting into
the incorrect slot when the connector panel replacement
and others.
w
Do not install with turning the power on
Touching the power contact portion or the primary wind-
ing circuit may cause electric shock.
For safety reason, turn off the power and unplug the
appliance from the outlet before starting the installation.
Procedures
1. Turn off the power of SIU-80 and unplug the appli-
ance from the outlet.
2. Remove the rear blank panel. (Refer to the Installation
Manual supplied with the SIU-80.)
3. Attach the model label supplied with the BKSI-2010 in
the chassis near the slot to install the board.
n
After the connector panel is inserted into a slot, the
model label cannot be seen.
4. Insert the connector panel to the matching slot and fix
the panel by the two screws securing the rear blank panel.
Connector panel removal
1. Turn off the power of SIU-80 and unplug the appli-
ance from the outlet.
2. Remove the two screws securing the connector panel
and remove the connector panel.
m
• When removing the connector panel, move the panel
to the right and left slowly until the connection with
the mother board is sufficiently loose, then remove
the connector panel slowly.
• Panels must be held by the plugs of the cables which
are connected to the BNC cables.
2-3. Notice in Power on
After installing BKSI-2010 into SIU-80, turn on the power
of SIU-80.
Before turning on the power of SIU-80, always make sure
that the power of the disk drives is set to off. If the power
of the disk drive is turned on before SIU-80, an error may
occur in the disk drives.
If so, turn off the power of SIU-80 first, and next the disk
drives.
Then, turn on the power in the sequence of SIU-80 and
disk drives.
SIU-80
Rear blank panel
BVTT 3
×
6
SIU-80
BVTT 3
×
6
Connector panel
Model label