C:\2030940_ACYRK81\4665334011\4665334011ACY_RK81GB\01GB02C01-WW.fm
masterpage: Left.L1+L1
ACY-RK81
4-665-334-01 (1)
Introduction /
10
Introduction
This Rack Mounting Kit can be used to mount the AIT
library in an EIA Standard 19-inch rack. For installation
instructions, contact Sony Service Support Center.
(Charges apply.)
Caution
Do not remove any screws other than those indicated
in this manual. Doing so may cause the AIT library
to fall, resulting in personal injury or damage to the
AIT library.
The AIT library weighs approximately 13.5 kg / 29.8
lbs.
At least two people are needed in order to handle the
library. Handling the AIT library on your own could
result in back injury or other accidents resulting in
injury or damage to the AIT library.
Before beginning work, always press the power
switch on the rear to turn the power off, and then
disconnect all the cables.
Required Tools
The following tools are needed in order to mount the
Rack Mounting Kit:
• Philips screwdriver
Cautions Concerning Installation
Check the following points before mounting the AIT
library in a rack.
• Install the library in an operating environment with a
temperature range of 10 to 35 °C, and a humidity
range of 20 to 80 %. We recommend installing the
library in an indoor location where the temperature is
maintained between 15 and 25 °C.
• When installing the library, keep cables and other
obstructions away from the area around the fan on the
rear of the library and the ventilation holes on the front
of the library.
• When the library is mounted in a rack, the balance of
the rack could be affected and the rack could tip over.
To prevent this from happening, we recommend
securing the rack with brackets that are designed to
keep it from tipping over.
• Confirm that the correct power is being supplied to all
of the equipment in the rack.
• Confirm that the power outlet and power cord that you
are using are properly grounded.
• When installing the Rack Mounting Kit, take all
precautions necessary in order to prevent electrostatic
discharge while work is in progress, including using
antistatic mats and wristbands.
Compatible Rack Holes
The Rack Mounting Kit is compatible with the
following shapes of screw holes. Mount the rail
assembly bracket on the rack frame as follows,
depending on the rack screw hole shape.
Angled holes:
s
9.2 to 10.0 mm
Circular holes:
φ
7.1 to 8.0 mm
Holes other than the above
Remove the positioning pins and replace them with
ordinary screws.
1
Loosen the hexagon socket head screw, and then
remove the positioning pins from the bracket.
2
Using ordinary screws, washers, and nuts, secure the
bracket to the rack frame.
Positioning pin
Set screw
Bracket
Rack frame
Hexagon socket
head screws
Positioning pin
Set screw
Bracket
Rack frame
Hexagon socket
head screws
Space
Screw
Washer
Bracket
Rack frame
Nat
Space
Screw
Summary of Contents for ACY-RK81
Page 16: ...Printed in Japan ...
